​​Where is the physical entrance for the model setting? ​ ​
Newbie who are new to LED screens often worry:​ ​The model setting item cannot be found through the menu in the control software​ ​. In fact, this problem starts with the hardware structure. The model configuration of modern LED screens usually has three entrances:

• ​​Receive card dial switch​ ​: 8-bit dialing group in the corner of the PCB board, set with binary encoding
• ​​System control box​ ​: 7-segment digital tube on metal shell, enter the model code through key combination
• ​​Software cloud synchronization​ ​: Some models that support the Internet of Things can be automatically identified through encryption protocols

A commercial complex project once caused the entire wall to display a screen due to a dial error, and later technicians discovered that​ ​Poor oxidation contact of 3rd position​ ​. So, when encountering model setting problems, check the cleanliness of the hardware interface first.

​​Parameter matching comparison table​​

​​Golden Rules for Parameter Setting​​：

1. Brightness value = ambient illuminance × 1.2-1.5 times (take the low value indoors)
2. Refresh rate ≥ Camera frame rate × 2
3. ​​Grayscale is better than low​ ​, avoid color block faults

There is a case that is very interesting - a screen of a concert appeared, and finally found that it was​ ​The default 1920Hz refresh rate of the model has not been changed to 4000Hz​ ​. It’s like running the track with a grocery car, how can you not fail!

​​System debugging guide to avoid pits​​
​​Why are the parameters adjusted correctly or they still display exceptions? ​ ​ This problem is most likely in the signal link:

1. The firmware versions of the sending card and receiving card must match (Error ≤ Version 0.2)
2. The network cable must be shielded with a category six (transmission distance > 80 meters plus relay)
3. The power supply phase must be consistent (the three-phase electrical connection is incorrectly burned 18 receiving cards for a certain project)

Let’s focus on the power phase problem:​ ​Power on after testing with a phase detector​ ​, this step can avoid 90% of hardware damage. The most outrageous case I have ever seen is that the ground wire is charged and the control chip is directly penetrated.

Now I know why some display screens can last for ten years without any problems? The model setting is not as simple as entering a few numbers, and it requires a comprehensive diagnosis like an old Chinese doctor taking the pulse. I heard that the new generation of smart screens can automatically recognize models, but we still have to practice the basic skills solidly. Remember, the parameter setting is like adding salt to stir-frying dishes. If you shake your hands, you will destroy the whole dish!

for more product information and pricing, please contact us .